Instructions
Basic Instruction for Assembling Tables: TMT 03, 05, 07, 08, 09
- Assemble Base and Legs first.
Take the legs and attach the cross brace. There are either
numbers or letters to match a side.
- Assemble Table Top to Base and Legs.
Place the tabletop and rest it on top of the base. The
legs should slide into place if they are in the right position. If they
do not fit then take the table top off and rotate it half way around and try
to fit the legs in again. There are either numbers of letters to match
a side.
- Secure Table Top to Base and Legs with Screws or Dowels.
If you have Brass Screws you need 10 to 12, depending on
your model. Use 4 long screws down low on the base and 4 long screws
at the top of the legs, where the table rest on the legs. You will need
to open the table with the leaf folded inside and the last 2 or 4 screws will
go down from the top, where the leaf comes out. If you have Brass Screws you need 10 to 12, depending on
your model. Use 4 long screws down low on the base and 4 long screws
at the top of the legs, where the table rest on the legs. You will need
to open the table with the leaf folded inside and the last 2 or 4 screws will
go down from the top, where the leaf comes out. If you have the Wood Dowels take a good wood glue (Elmer's)
and rub it all over the wood dowels and using a small hammer or rubber mallet,
hammer them in. You may have to cut some excess wood off from the dowels.
- Let table dry for 24 hours before use.
>Please note: Each table is Hand Made and will only go back
together the same way it came apart. If any parts or holes do not match
up try rotating Base, Legs, and/or Top. If you have questions please
call us at 1-888-721-BARR.
|
